Hi Patrick,
Thanks for your feedback. About to scan particular sectors without repairing all. You can select the “Scan and Repair” or “Scan Only”, then choose the starting sector parameter. Enter the sector value if you wish to check the hard drive not from the first sector. If you don’t wish to check the 1st 3 GB of the hdd just to save time, because you are sure, this area of the surface doesn’t have bad sectors. In such cases enter the offset equal to 3000 with ‘m’ following or 6144000 without ‘m’ following (number of sectors 3000x1024x1024/512=6144000).